I'm hoping someone can provide me some ideas of where to go from here. I crashed my p3a a couple weeks ago breaking the yaw control arm and ribbon cable on the gimbal. Replaced both pieces this weekend. Now when I turn the bird on it powers up, the camera goes through the normal cycle moving around and I can roll the camera up and down from the remote for about 5 seconds then it just stops and sits there. I never get video feed to the controller, only black screen.
I double checked the two cable connections that go into the top of the gimbal from the phantom, pulled both off and reattached them just to be sure they were connected. Double checked ribbon cable connections and they all seem to be secure as well. At first DJI Go was seeing it as a P3P. I uninstalled the app and reinstalled the latest version which now sees it as an Inspire instead.
Any ideas?
I double checked the two cable connections that go into the top of the gimbal from the phantom, pulled both off and reattached them just to be sure they were connected. Double checked ribbon cable connections and they all seem to be secure as well. At first DJI Go was seeing it as a P3P. I uninstalled the app and reinstalled the latest version which now sees it as an Inspire instead.
Any ideas?