.....................
I have the latest firmware on a brand new GL300K and I can't figure out how to get Litchi "connected" to the P4Pv2+
I do this steps:
- I boot the controller, install from browser Amazon Store
- installed from the store Litchi
- Connected the USB Cable
... nothing happens, no window....................................
Federico
Almost a month later. Was hoping to read more replies on this thread.
I do see you have the P4Pv2 and this thread started for the P4P+ and CrystalSky.
I'm researching this as I have the P4P+, wanting to load Litchi and/or Pix4d and am searching to read a clear concise thread on how to do so without risk.
Something that did catch my eye when reading your reply was the you "Connected the USB Cable " and it may be seen as a pen drive.
Just learning but from what I've read, the USB cable must be connected like a jumper (i.e. both ends connected to the RC).
I assume you are doing that, but thought I'd piont that out.