Hi everyone
Purchased a pro 3 and software was out of date so undertook the firmware / calibration watched a thousand flights and tutorials etc and then noticed gimbal disconnect message
I have live feed and gimbal is fully controllable, however when i press record button the footage is choppy and unusable
Ive never crashed and have tried a million fixes from all over the internet
Is this a firmware issue and i need to wait for a new firmware update, or shall i change the gimbal ribbon cable? I am sure ive read that there is a new firmware release that addresses this issue, anyone else aware of this?
So frustrated to be grounded, so any advice would be greatly appreciated
Many thanks, and i have to say that finding this site has been so very helpful as a new p3p owner and the advice / tips have been absolutely invaluable .
Happy and safe flying
Purchased a pro 3 and software was out of date so undertook the firmware / calibration watched a thousand flights and tutorials etc and then noticed gimbal disconnect message
I have live feed and gimbal is fully controllable, however when i press record button the footage is choppy and unusable
Ive never crashed and have tried a million fixes from all over the internet
Is this a firmware issue and i need to wait for a new firmware update, or shall i change the gimbal ribbon cable? I am sure ive read that there is a new firmware release that addresses this issue, anyone else aware of this?
So frustrated to be grounded, so any advice would be greatly appreciated
Many thanks, and i have to say that finding this site has been so very helpful as a new p3p owner and the advice / tips have been absolutely invaluable .
Happy and safe flying