Just found some interference in my gopro video right after start up. I moved some wires around inside the phantom for my VTX just before this video was taken.
I'm thinking one of my wires is too close to another wire but not sure what to look for. This is the first time I've seen interference on my gopro videos.
What causes the most interference in the case? ESCs? Battery? Any other best practices for the zenmuse wiring layout?
http://youtu.be/j-7NMvIH5wc
BTW, the video did clear up after some time with only very faint interference during some hard lift.
Thanks for any help. These lines are devastating!
Edit: Phantom V2, Zenmuse H3-3D with anti-interference board installed.
I'm thinking one of my wires is too close to another wire but not sure what to look for. This is the first time I've seen interference on my gopro videos.
What causes the most interference in the case? ESCs? Battery? Any other best practices for the zenmuse wiring layout?
http://youtu.be/j-7NMvIH5wc
BTW, the video did clear up after some time with only very faint interference during some hard lift.
Thanks for any help. These lines are devastating!
Edit: Phantom V2, Zenmuse H3-3D with anti-interference board installed.