I crashed my DJI Phantom 3 Adv. During the crash the gimbal ribbon cable ripped and the gimbal roll arm broke. I ordered a new ribbon cable, roll arm and a pitch motor just in case the current pitch motor also got damaged during the crash. I just installed the new ribbon cable, roll arm and pitch motor. After turning on the drone, image transmission works fine and also the LED light on the gimbal are blinking (fast green blinking during startup and then slow red blinking). Only issue is that the gimbal is completly dead. It doesn't react/level during startup and also doesn't react to any remote control comands. Just hangs down dead from the drone the entire time. The DJI App displays "Gimbal Roll Error" and "Hardware Malfunction. Contact DJI Support for repairs". I just don't know where to look for the error...
As the image transmission is working and the LED is blinking, the new ribbon cable has to be installed correctly and the gimbal is recieving electricity. I think its highly unlikely that Yaw, Roll and Pitch Motor are all damaged at the same time. Any ideas? If the Roll Motor is damaged, shouldn't the Yaw and Pitch Motor continue working?
As the image transmission is working and the LED is blinking, the new ribbon cable has to be installed correctly and the gimbal is recieving electricity. I think its highly unlikely that Yaw, Roll and Pitch Motor are all damaged at the same time. Any ideas? If the Roll Motor is damaged, shouldn't the Yaw and Pitch Motor continue working?