How to remove gimbal!

[ben.gopo]

Okay so recently I had a bit of a crash with my drone, nothing was damaged except for the vibration board above the gimbal. I ordered a spare vibration board but was wondering how to take out the old one and install the new one. Any ideas?

Sent from my iPhone using PhantomPilots mobile app

 

[Air Ontario]

Push the disk on the clear pin upwards on the pin shaft. That will temporarily stretch the hole in the plastic disk. After a couple of minutes, slide the plastic disk off the pointed end of pin.

The disk will shrink back quickly and can actually be used again if you wish.

There are 4 screws holding the old vibration plate. Be sure to note how the grey multiwire plugs are routed between the body and plate so that you can duplicate those when replacing with the new plate.

 

[msinger]

 

[ben.gopo]

Thanks guys! I got it!


Sent from my iPhone using PhantomPilots mobile app