So I crashed yesterday. Not the first time, surely not the last, but this time my casualties were more severe. I got a little too close to the trees (a common denominator in all of my crashes), and by the time I went to gather the pieces, the camera and battery were both separated from the P2V. The battery connections were "mashed in" to the housing and while I can get a charger on it and it seems to charge, there's no way it will connect to the P2V. There goes my free extra battery, no bother I have a spare.
So i get my prop guards (ya think?), and DJI factory replacement props in the mail today. Get everything put together before the sun sets, and go to start up and notice that one of my LEDs isn't blinking, the port side rear to be exact and nautical. Then I start the motors and its a no go on that arm. So...no blinky , no spinny. What do you guys think and where should I start? Oh and I wasn't rolling during the crash, actually trying to get some photos of the neighbors' house (they winter in FL), to send them. This was the last photo on the card--pretty sure what I hit.
So i get my prop guards (ya think?), and DJI factory replacement props in the mail today. Get everything put together before the sun sets, and go to start up and notice that one of my LEDs isn't blinking, the port side rear to be exact and nautical. Then I start the motors and its a no go on that arm. So...no blinky , no spinny. What do you guys think and where should I start? Oh and I wasn't rolling during the crash, actually trying to get some photos of the neighbors' house (they winter in FL), to send them. This was the last photo on the card--pretty sure what I hit.