So finally got round to getting the P3S going today and after getting batteries all up to full on controller and drone was ready for the initial startup.
Needed new firmware and got that done - although when starting the drone (first time) the gimbal is wacking side to side up and down and keeps on doing this and does not settle to central position. get the gimbal motor overload warning and thats pretty much it.
Drone never flown - in fact don't think motors have even run yet - and this thing is basically a brick right now.
Ive searched on line about this and many have had this issue after a wipeout or some damage so pretty bummed to have this issue on first startup.
All screws and grub screws tight etc ... some basic checks as suggested on web done but not joy.
Have an email into DJI now but thats Monday before they come back at the earliest. Any suggestions?
Thanks
Needed new firmware and got that done - although when starting the drone (first time) the gimbal is wacking side to side up and down and keeps on doing this and does not settle to central position. get the gimbal motor overload warning and thats pretty much it.
Drone never flown - in fact don't think motors have even run yet - and this thing is basically a brick right now.
Ive searched on line about this and many have had this issue after a wipeout or some damage so pretty bummed to have this issue on first startup.
All screws and grub screws tight etc ... some basic checks as suggested on web done but not joy.
Have an email into DJI now but thats Monday before they come back at the earliest. Any suggestions?
Thanks