I have a weird one. I flew my P3P last Sunday with no issues. Put everything away as usual.
Took everything out this afternoon to fly, setup with DJI Go, launched, went up to around 100 feet and started checking the horizon, exposure, etc. When I went to adjust the gimbal pitch I get nothing. I have the C1 button set to pitch down and forward so I hit it and it works fine but the manual control is dead.
I bring it back in, land with no issues and take it back to the house to check out. I do an RC calibration and all the controls respond during calibration including the gimbal pitch. When I connect back to the AC the gimbal pitch does not work. I tried re-calibrating the gimbal, the IMU, the RC, with no luck. It's like the gimbal pitch wheel is turned of. If the wheel was defective, why does it respond during calibration? I have never crashed the AC or damaged the gimbal in any way. Any suggestions?
Took everything out this afternoon to fly, setup with DJI Go, launched, went up to around 100 feet and started checking the horizon, exposure, etc. When I went to adjust the gimbal pitch I get nothing. I have the C1 button set to pitch down and forward so I hit it and it works fine but the manual control is dead.
I bring it back in, land with no issues and take it back to the house to check out. I do an RC calibration and all the controls respond during calibration including the gimbal pitch. When I connect back to the AC the gimbal pitch does not work. I tried re-calibrating the gimbal, the IMU, the RC, with no luck. It's like the gimbal pitch wheel is turned of. If the wheel was defective, why does it respond during calibration? I have never crashed the AC or damaged the gimbal in any way. Any suggestions?