I took my P3A out the other night to get some shots of the sunset, everything went great, no issues the whole time. Finished up, packed everything up and headed home. Got the quad out this evening and upon startup, there is no image on my iPad mini 4, I have the "no image transmission" message and when I open the menu by tapping top of screen in dji go, I see "gimbal disconnected" next to gimbal status. When powered up, the gimbal acts as it usually does with its little dance and it centers correctly, green light flashing on gimbal, and I can move the camera up and down with the r/c. I have never crashed the quad and I'm the only owner. Not sure if it is related but I noticed this last time I signed into go dji, it kept defaulting to a professional instead of an advanced. I started up the motors and it recorded a flight, when looking at the flight, it has my quad as a professional. Looked around and haven't found anything that has helped, any suggestions are greatly appreciated. My thinking is something got messed up with the firmware, but I can't understand how it could happen when i hadn't done anything with it since my last flight.