Hi all. I'm hoping someone has a fix for me. I've had my P2V+ for a couple of months and have enjoyed several fun flights so far. Recently I was flying over a pond and inadvertently got too close to the fountain in the middle. Things got wet only briefly and I was able to fly it back to me. Its been suitably dried. Now when I turn it on the camera works but it hangs like a wet noodle. The gimbal does nothing and I keep getting a message saying "Remove Gimbal Lock".
Any ideas? Is the Gimbal toast??
I've done several power cycles, updated all firmware to latest available and done an advanced IMU calibration.
No change.
Any ideas or advice (other than dont let it go swimming again) appreciated.
If I need a new Gimbal would this be a good time to upgrade to be able to use a GoPRO?
Looking forward to getting back to flying and taking pics again.
Thank you.
Any ideas? Is the Gimbal toast??
I've done several power cycles, updated all firmware to latest available and done an advanced IMU calibration.
No change.
Any ideas or advice (other than dont let it go swimming again) appreciated.
If I need a new Gimbal would this be a good time to upgrade to be able to use a GoPRO?
Looking forward to getting back to flying and taking pics again.
Thank you.