I own a P2V and recently picked up a wrecked P2V+. After replacing two motors, the shell and replacing a ribbon cable and updating the software I decided to fire it up. Something I noticed right away is there was no "three beeps" at the end of the start up sequence like the P2V has. Is this normal for a P2V+ or could it be because the gimbal/camera were not attached? They were beyond repair so I had planned on adding a Zenmuse H3-3D and a Go Pro Hero 3 to it.
The Pv2+ flys fine, seems to lock on to GPS without issue (according to LED indication/smartphone app) however I have noticed that I can't seem to calibrate the compass by switching the S1 switch like I can the P2V.
It came from about 30 miles from where I live so I really didn't think there would be much of a magnetic difference but I suppose I should be glad it didn't take off or something.
Any thoughts on why I can't calibrate the compass and if the P2V+ is supposed to have the same audible start-up sounds as the P2V?
Thanks much for your time and knowledge!
Viro
The Pv2+ flys fine, seems to lock on to GPS without issue (according to LED indication/smartphone app) however I have noticed that I can't seem to calibrate the compass by switching the S1 switch like I can the P2V.
It came from about 30 miles from where I live so I really didn't think there would be much of a magnetic difference but I suppose I should be glad it didn't take off or something.
Any thoughts on why I can't calibrate the compass and if the P2V+ is supposed to have the same audible start-up sounds as the P2V?
Thanks much for your time and knowledge!
Viro