Pic 1: need new anti vibration board and cable set,
Pic 2 new shell
Pic 3 same as 1
Pic 4 yes the cable goes to the cam, it will be in the cable pack you buy
Pic 5, check after repairs done
Pic 6 loosen the set screw on the gimbal yaw arm and bring it off the “trackpad” a bit then tighten
Pic 7 that is off the main board mount inside the body, not a part currently sold and you do need it to secure the main board, I recommend getting some double sided foam or tape and taping the main board down
Pic 2 new shell
Pic 3 same as 1
Pic 4 yes the cable goes to the cam, it will be in the cable pack you buy
Pic 5, check after repairs done
Pic 6 loosen the set screw on the gimbal yaw arm and bring it off the “trackpad” a bit then tighten
Pic 7 that is off the main board mount inside the body, not a part currently sold and you do need it to secure the main board, I recommend getting some double sided foam or tape and taping the main board down