Help.
Tried installing Zenmuse last night, all seemed to go well. Had to search forum for answer to why gimbal only pointed at ground,success. Went out for a test flight, start up good gps obtained now time for take off. As soon as I took off it started wobbling out of control.It's hard to describe the flight pattern, but even with minimum throttle the craft starts to oscillate,stable flight is impossible. Luckily I didn't have too much height so the resulting crash landing only damaged a carbon fibre prop.
Plugged phantom into pc and did calibration check and advanced calibration just in case. checked all the wiring then went out for another test, same disaster.
So this morning took gimbal off and restored to original status, went out for test flight and still uncontrollable wobble. Have tried to fly in att mode to see if it was gps or compass problem but same story. Have now taken apart again to have a look and everything looks in place, so I'm lost.
Please anybody got any bright ideas
Tried installing Zenmuse last night, all seemed to go well. Had to search forum for answer to why gimbal only pointed at ground,success. Went out for a test flight, start up good gps obtained now time for take off. As soon as I took off it started wobbling out of control.It's hard to describe the flight pattern, but even with minimum throttle the craft starts to oscillate,stable flight is impossible. Luckily I didn't have too much height so the resulting crash landing only damaged a carbon fibre prop.
Plugged phantom into pc and did calibration check and advanced calibration just in case. checked all the wiring then went out for another test, same disaster.
So this morning took gimbal off and restored to original status, went out for test flight and still uncontrollable wobble. Have tried to fly in att mode to see if it was gps or compass problem but same story. Have now taken apart again to have a look and everything looks in place, so I'm lost.
Please anybody got any bright ideas