How to Bind the Camera & Range Extender
If the camera and range extender connection is lost, or one of them needs to be repaired or replaced,
a camera and range extender binding will need to be performed via the DJI VISION App.
1.Power on the camera and range extender. Note: (Place the camera power switch to the ’WIFION‘ position).
2.Approximately 30 seconds later, press the reset button on the range extender with a thin object until the Wi-Fi signal indicator turns off. The range extender will then restart automatically.
3.Approximately30 seconds later, the Wi-Fi signal indicator should start to blink green, which indicates the range extenders now ready to be bound.
4.Find and select the Phantom_1xxxxx via the Wi-Fi list on the mobile device to connect the range extender.
5.(Fig.1) Run the DJI VISION App->Settings->General->Binding. (Fig.2)Select’Scan the QR Code’ to scan the camera QR code on the product packaging. (Fig.3) Get the camera SSID
(E.g. FC200_0xxxxx) and the MAC address, select the check mark on the top right corner. The range extender should automatically restart. The binding procedure is now complete.
Don't forge to check the check mark twice.
Caution
If both the camera and range extender are powered on and working normally, you will be able to find the SSID on the Wi-Fi list of the mobile device.
DO NOT push the reset button of the range extender unless you are ready to rebind the range extender and the camera! This will unbind your camera and you must follow the steps above to rebind.
The QR code is located on the packaging of the PHANTOM 2 VISION. If you cannot find the QR code, please contact DJI customer service to receive the QR code related to your camera’ serial number.