This is a used P3S that I bought crashed with the roll motor seperated.
I just replaced both gimbal arms and the ribbon.
When I first tried to set up the go app it was on my Samsung note 3. The app kept wanting me to upgrade the firmware. But I don't think I did. At least not on purpose.
Now I've set the go app up on my ipad mini 2. I'm not getting the request to update the firmware. I assume it did it on it's own.
I've done all the calibrations that I can find. But the camera seems to be looking a little to the right. Is there a calibration for that.
While I was adjusting things some strange things happened. The camera would not move up and down. But it would take a picture. And the motors would not start. I restarted the app and everything seems to be working now.
Also. When I put my hand over the craft to pick it up I hear "Atti Mode" from the app. And it shows I've lost gps. I tried taking it outside and get the same thing.
Please advise. Thanks.
I just replaced both gimbal arms and the ribbon.
When I first tried to set up the go app it was on my Samsung note 3. The app kept wanting me to upgrade the firmware. But I don't think I did. At least not on purpose.
Now I've set the go app up on my ipad mini 2. I'm not getting the request to update the firmware. I assume it did it on it's own.
I've done all the calibrations that I can find. But the camera seems to be looking a little to the right. Is there a calibration for that.
While I was adjusting things some strange things happened. The camera would not move up and down. But it would take a picture. And the motors would not start. I restarted the app and everything seems to be working now.
Also. When I put my hand over the craft to pick it up I hear "Atti Mode" from the app. And it shows I've lost gps. I tried taking it outside and get the same thing.
Please advise. Thanks.