Might be a stupid question, but I'm installing my Boscam TS353 400mw vtx and it came with a plastic shrink wrap on it. So I remove it right? Wasn't sure if it was supposed to protect the electronics.
Also, I was planning to double side tape it to the bottom of the P2. But 1 side has the exposed electronics and the other has the heat sink. How should I attach it? I guess tape the heat sink to the phantom? Does it get pretty warm?
Also, I'm installing with the iosd mini. The green, white and red cable are not needed right? Was going to trim those off. I just need the yellow and black and the red and black, right?
Thanks.
Also, I was planning to double side tape it to the bottom of the P2. But 1 side has the exposed electronics and the other has the heat sink. How should I attach it? I guess tape the heat sink to the phantom? Does it get pretty warm?
Also, I'm installing with the iosd mini. The green, white and red cable are not needed right? Was going to trim those off. I just need the yellow and black and the red and black, right?
Thanks.