I just completed setting up my Futaba 14SG tx (with RS7008SB receiver) with my Phantom. I scavenged a few resources online but came out with a specific setup for the Phantom (Naza + H3-2D)
I could write a step by step guide if some people are interested. Basically what I have done :
-Basic working 4 control axis (Aileron, Elevator, Rudder and Throttle)
-Dual Rate switch to slow down one or more control axis for smoother control when filming
-Off - Course Lock - Home Lock switch working on any 3 position switch
-GPS Atti - Atti - Manual switch on any 3 position switch
-Failsafe Override Switch (forces Failsafe regardless of the position of the flight mode switch) using control mixing
-Failsafe configuration for loss of TX contact (activates NAZA Failsafe when loosing contact)
-Gimbal control (H3-2D) on any analog input (I chose the left volume button on front)
-Remote Telemetry Alarms (RX Voltage and Battery Voltage Alert)
-Auto Timer when taking off and shutting down motor. Configurable switch to reset
-Telemetry saving to SD Card configurable switch to turn off and on
So, any interest? I don't want to waste 3hours to do something no one is interested in. It was pretty straight forward for me since I'm used to Futaba controllers but I guess if it helps someone, that'll be nice
Edit : Posted here : http://www.phantompilots.com/threads/howto-install-a-futaba-14sg-tx-on-your-phantom.3931/#post-64425
I could write a step by step guide if some people are interested. Basically what I have done :
-Basic working 4 control axis (Aileron, Elevator, Rudder and Throttle)
-Dual Rate switch to slow down one or more control axis for smoother control when filming
-Off - Course Lock - Home Lock switch working on any 3 position switch
-GPS Atti - Atti - Manual switch on any 3 position switch
-Failsafe Override Switch (forces Failsafe regardless of the position of the flight mode switch) using control mixing
-Failsafe configuration for loss of TX contact (activates NAZA Failsafe when loosing contact)
-Gimbal control (H3-2D) on any analog input (I chose the left volume button on front)
-Remote Telemetry Alarms (RX Voltage and Battery Voltage Alert)
-Auto Timer when taking off and shutting down motor. Configurable switch to reset
-Telemetry saving to SD Card configurable switch to turn off and on
So, any interest? I don't want to waste 3hours to do something no one is interested in. It was pretty straight forward for me since I'm used to Futaba controllers but I guess if it helps someone, that'll be nice
Edit : Posted here : http://www.phantompilots.com/threads/howto-install-a-futaba-14sg-tx-on-your-phantom.3931/#post-64425
Last edited: