Hello, any help would be much much appreciated.
I crashed my P3S, replaced flat ribbon cable, now after power on I get a slow yellow blinking light, I can move the camera slightly with the controller, but the DJI App says controller is connected but the aircraft is not. I re-formatted the SDCard and nothing changed. A few hours ago I was able to actually fly the drone without it being connected to the DJI app, but now I can't for some reason.
Is there a way to run diagnostics on this and see what the problem is? Does NAZAM work with Phantom 3 or are there any other apps to see diagnostics and logs files(I checked the ones on the sd card but found nothing other than firmware update success messages).
Thank you for reading this and hopefully you can shed some light on these problems.
I crashed my P3S, replaced flat ribbon cable, now after power on I get a slow yellow blinking light, I can move the camera slightly with the controller, but the DJI App says controller is connected but the aircraft is not. I re-formatted the SDCard and nothing changed. A few hours ago I was able to actually fly the drone without it being connected to the DJI app, but now I can't for some reason.
Is there a way to run diagnostics on this and see what the problem is? Does NAZAM work with Phantom 3 or are there any other apps to see diagnostics and logs files(I checked the ones on the sd card but found nothing other than firmware update success messages).
Thank you for reading this and hopefully you can shed some light on these problems.