Members-
Today I upgraded with the new transmitter and the binding went well. While I was connected
with the computer I did the new software update to ver 3.12. Anytime I do an update I always do
an advanced IMU calibration. The green bar was moving as it usually does and stops about 3/4
way and hangs. I waited 30 min. and it just quit. Shut everything down including the computer
and rebooted. Connected everything up and received a message calibration needed. This time
everything went normal. Everything seems normal. I went to my normal takeoff point and started
up and all systems good. Did the compass dance and ended with 7 sats. When I took off- it
hovered at 10 ft. and did a hard bank to the right and flew uncontrollable to a tree 40 ft. away
at full speed and my sticks were centered.
This Phantom is 6 months old and maybe 40 flights. I have never had a problem and
really trusted it.
Was this error in IMU calibration a warning? Should I have reinstalled the update- if
this is possible?
Thanks- Al
Today I upgraded with the new transmitter and the binding went well. While I was connected
with the computer I did the new software update to ver 3.12. Anytime I do an update I always do
an advanced IMU calibration. The green bar was moving as it usually does and stops about 3/4
way and hangs. I waited 30 min. and it just quit. Shut everything down including the computer
and rebooted. Connected everything up and received a message calibration needed. This time
everything went normal. Everything seems normal. I went to my normal takeoff point and started
up and all systems good. Did the compass dance and ended with 7 sats. When I took off- it
hovered at 10 ft. and did a hard bank to the right and flew uncontrollable to a tree 40 ft. away
at full speed and my sticks were centered.
This Phantom is 6 months old and maybe 40 flights. I have never had a problem and
really trusted it.
Was this error in IMU calibration a warning? Should I have reinstalled the update- if
this is possible?
Thanks- Al