Recent content by jaytrizzle

I have a battery that is less than 2 months old. used it probably less than 5 times. All the other 3 batteries I have are fine. This one won't start up the motors. Battery is full. Red light after yellow stays on. I tried taking it out and turning it on/off outside the P2 and it worked last...

hey i did an advanced cali under IMU Cali (under tools) and it seemed to do the trick. how come its under IMU? isnt that the gimbal? also is the right stick supposed to be able to control the gimbal? i dont remember it doing that before.

Updated software yesterday and i think it was working yesterday. I turned on manual and fail safe and now the motors won't start after both, turned off manual and failsafe and motors started working again. then turned on FS and motor stopped starting again. then turned off FS and now still won't...

Hey OI, I switched the ribbon cable. Didn't do a thing. Any other ideas? I might call B&H and see if they have any ideas.

anyone here?

I had a slightly rough landing on grass last week about a 5 foot drop - only one of the prop guards fell off. I had the quick disconnects so there was completely no physical damage as far as I could tell. I didn't remember if FPV was still working when I turned it off but a couple of days later...

I always fly with prop guards - safety's first

Thanks Noiseboy! But this cage is not exactly square. The openings are all different shapes and sizes. How will i have FPV if I take off the TX?

Thanks guys, esp. Noiseboy!

Hi Pilots, I am filming a project with my P2 with FPV but the final shot will involve me flying through a large cage thats sitting in a fountain. The widest opening of the cage are about 10ft wide and about 5 feet tall. However, the hard part is the shot: 1. Fly into the cage from about 50-70...

So 15 a month, in 10 months its $150. why not get this for $127 and no cell fees? http://www.amazon.com/dp/B00IKNQVCA/ref ... 8T3ERE3AMC does anyoen know the size/weight comparisons for these 2?

would you suggest bluebeam ultras or these fatsharks: http://www.amazon.com/5-8GHz-Fatshark-s ... tx+antenna

Thanks, guys. So at this point, should I get another TX or another antenna? I eventually I may get both, but ATM, I already plopped down 2k + batteries.

Noiseboy, The reciever is a Delvcam 7" FPV Monitor with Dual 5.8GHz Wireless Receiver. I was able to get 400 meters verticallly but horizontally, the range is still about 120 meters tops.

After a rough landing, the gimbal is leveling slanted/tilted (even if the P2 is on a table) and footage from the GoPro 3 is slanted. All 3 axis of stabilization seem to work. Is this something i or my mechanic friend can fix? Thanks