Jezabel said:
UFOwiththeGoPro, I, too, had this problem and found that the SEQUENCE matters when doing the calibration of the gimbal switch. B & H did NOT know this when I inquired and were going to have me send the entire package back. It was this forum and information about this and doing upgrades that had solved the problem for me and I hope will for others, too.
Yes DJI and everyone is discovering that order/sequence matters! here is what I have posted before including the 4 steps that work. do them in order and do not skip anything
What I did wrong: I did the Firmware updates to the TX and Aircraft (main controller) in the WRONG ORDER which caused the gimbal pitch control to STOP WORKING
How I fixed it: Redid the firmware updates to the tx and aircraft in the CORRECT ORDER (steps 1 thru 4) including calibrations as follows below:
1) Plug in the remote controller with the provided usb cable and Use the PHANTOM RC Assistant software to upgrade the Remote Controller firmware to V1.0.1.11.
2) Calibrate the sticks and X1 channel of the Remote Controller using PHANTOM RC Assistant software.
3) Now Plug in the aircraft with the provided usb cord and Use the PHANTOM 2 Assistant software to upgrade the Gimbal IMU firmware to V1.8 on the Upgrade page.
4) After upgrade completed, calibrate the X1 channel of Main controller using PHANTOM 2 Assistant software,
then the PHANTOM 2 will work well with H3-2D.
So in conclusion....update the firmware on the transmitter first and calibrate it..........then update firmware for the aircraft (maincontroller) and calibrate it as well.
Please let us know if this works for you so we can further spread the word and extinguish this problem for good!