- Joined
- Jun 30, 2013
- Messages
- 134
- Reaction score
- 0
Bought one of these to connect my Zenmuse to my FPV TX.
Really impressed and makes a very neat job.
http://bit.ly/1aCWmDm
Really impressed and makes a very neat job.
http://bit.ly/1aCWmDm
MKheng said:Bought one of these to connect my Zenmuse to my FPV TX.
Really impressed and makes a very neat job.
http://bit.ly/1aCWmDm
Be sure to let us know how it works out. This configuration suggests that the tip plug is receiving 'V+' (~12 v whatever your 3s battery is putting out) while some DJI docs indicate that it's not outputting V+. However the fact that this cable appears to have been developed specifically for this application, suggests it will work. Cost (~$15US) seems a little high for a passive cable, but then if 'it just works' it may be worth it to many.
I have a Zenmuse mounted but have not hooked up a VTx yet. However since I used the Phantom upgrade board, I never installed the GCU module. The upgrade board has a 3 conductor cable that supplies Video Out, V+, and Ground. Since it's functionally identical to the original Phantom mother board + PMU v2 + GCU, it would make sense that both provide the V+ output. Guess you'll know for sure soon enough...
Steve
bern said:Videothis: I have just received this identical transmitter. As you have also discovered, there are no instructions with this unit. Have you successfully hooked it up yet? I thought I'd ask before I start an extensive experimentation program.
0U812 said:Thank god I found your post. I have been looking all over for an explanation of the 3 pin cable. I was going to guess on the colors, but I wanted confirmation. Why can't DJI english-speaking guys produce a decent installation manual/video?