Hi all,
I have a Turbo Ace Matrix w/ Naza 2, telemetry, 3 axis gimbal, controlled by DX9. Actually it’s my second. The first one dropped out the air suddenly over Yagul, Oaxaca, MX. I got a replacement aircraft. I had no trouble binding the new unit to the transmitter.
I had it on the shelf for a few months and when I next tried to fly, the aircraft was not bound to the TX. I bound it again and things were fine for a while. Then it started needing binding for every flight, then the TX failed completely. I sent it in for repair in September and brought it back to MX. When I go to bind it I get the audio confirmation “Bind complete.” However, it never actually communicates with the aircraft.
I plug it into the Naza assistant, but there’s nothing.
Here are two videos to show the situation:
I’m still down in Mexico and frankly I feel a bit stranded by the Turbo Ace group. Pretty bad support.
Any ideas would be most appreciated.
Thanks,
Tailspin
I have a Turbo Ace Matrix w/ Naza 2, telemetry, 3 axis gimbal, controlled by DX9. Actually it’s my second. The first one dropped out the air suddenly over Yagul, Oaxaca, MX. I got a replacement aircraft. I had no trouble binding the new unit to the transmitter.
I had it on the shelf for a few months and when I next tried to fly, the aircraft was not bound to the TX. I bound it again and things were fine for a while. Then it started needing binding for every flight, then the TX failed completely. I sent it in for repair in September and brought it back to MX. When I go to bind it I get the audio confirmation “Bind complete.” However, it never actually communicates with the aircraft.
I plug it into the Naza assistant, but there’s nothing.
Here are two videos to show the situation:
I’m still down in Mexico and frankly I feel a bit stranded by the Turbo Ace group. Pretty bad support.
Any ideas would be most appreciated.
Thanks,
Tailspin