I have a Phantom 4 Pro+ V2. It was put together and not bought as a unit. Everything works on it (no yaw drift!) except it has one quirk I'd like to fix. The controller will not link to the drone until I let the drone "warm up" for about 2 minutes and then power cycle it. After that it connects and stays connected. No issues at all after that. I believe it's the drone, not the controller as the controller can be on or off or power cycled and it still will not connect to the drone. Only when the drone has been power cycled after the "warm up" period will the controller connect. I'm not sure what part/board in the drone is responsible for the connection. Main board? If anyone has had this issue and was able to fix it I'd like to hear how you did it. Anyone that has some suggestions, I'm all ears.
Thanks,
Roger
Thanks,
Roger