Long story short...it was super bright outside today...somehow I managed to go thru the motions of turning off the p2v+ and even put the gimbal lock on and placed her in the case...walked around the car show for 15mins and drove home another 15mins...got her inside in a hurry to see the footage and opened the case to grab chip...bird was hot and camera was hotter....quickly powered down and placed over air vent for 10 mins till she was good and cold...powered back up and Im getting an IMU error...when I go into assistant it will not calibrate...have left running for 12-15minutes and it progresses and then starts over....also there is this little red light on the left side of the bird that is flashing that I have never seen before....any help is appreciated...please tell me I didnt ruin my phantom with this stupid mistake.