- Joined
- Jul 9, 2014
- Messages
- 6
- Reaction score
- 0
Greetings Fellow Pilots,
Have a Phantom 2 (non-Vision) with several hours in the air. Did a firmware upgrade (I thought) while updating my laptop with the drivers / manuals / downloads from DJI.
Long story short - The light on my controller turns on solid green then goes to solid yellow,whether the P2 is turned on or not. No motor start, etc. What's funny is that the rear lights on the P2 change from yellow to green if I leave the P2 on long enough to get GPS with the controller on. If I turn it off at that point, the P2 goes back to yellow, so it seems like there is SOME communication
On the computer, "RC" software sees the controller for calibration, Phantom software does not.
I'm sure I dorked up something in the upgrade process - Any help from the flying brothers and sisters out there would be hugely appreciated!
Thanks in advance...
Have a Phantom 2 (non-Vision) with several hours in the air. Did a firmware upgrade (I thought) while updating my laptop with the drivers / manuals / downloads from DJI.
Long story short - The light on my controller turns on solid green then goes to solid yellow,whether the P2 is turned on or not. No motor start, etc. What's funny is that the rear lights on the P2 change from yellow to green if I leave the P2 on long enough to get GPS with the controller on. If I turn it off at that point, the P2 goes back to yellow, so it seems like there is SOME communication
On the computer, "RC" software sees the controller for calibration, Phantom software does not.
I'm sure I dorked up something in the upgrade process - Any help from the flying brothers and sisters out there would be hugely appreciated!
Thanks in advance...