Updated my P3P today and I did an IMU calibration aswell.
After 20 secounds around there I got the message "NO SIGNAL" on top of the screen.
Everything was working propertly the image was there and the quad responded to my actions.
I haven`t had this before I updated to the new software.
The batteries, transmitter and P3P is updated propertly. Sucess message on all of them.
Attatched below you can see an image.
best regards
After 20 secounds around there I got the message "NO SIGNAL" on top of the screen.
Everything was working propertly the image was there and the quad responded to my actions.
I haven`t had this before I updated to the new software.
The batteries, transmitter and P3P is updated propertly. Sucess message on all of them.
Attatched below you can see an image.
best regards