Welcome to PhantomPilots.com

Sign up for a weekly email of the latest drone news & information

RC problem

Discussion in 'Standard/4k Discussion' started by Sergey Zamkovoy, Nov 9, 2015.

  1. Sergey Zamkovoy

    Joined:
    Nov 9, 2015
    Messages:
    3
    Likes Received:
    0
    I have bought Phantom 3 Standard two days ago. And I have a problem with RC. Almost each time when I turn on RC, I see this:

    After that I calibrate RC using DJI GO, and can fly... But next time (in just a few hours) I have the same problem when I turm on RC. What would you advice?
     
  2. msinger

    Approved Vendor

    Joined:
    Oct 30, 2014
    Messages:
    18,832
    Likes Received:
    5,546
    Location:
    US
    That blink pattern means your remote controller needs to be calibrated. If it cannot remember the calibration, then I'd recommend you contact DJI about a replacement.
     
  3. Sergey Zamkovoy

    Joined:
    Nov 9, 2015
    Messages:
    3
    Likes Received:
    0
    Maybe there is a way to do hard reset for RC?
     
  4. mikep2323

    Joined:
    Oct 26, 2015
    Messages:
    261
    Likes Received:
    57
    Mine does that also until i connect it to the phantom. As soon as they connect with wifi it turns green. So what is it supposed to do? I'm wondering if I need to calabraite it.
     
  5. dirkclod

    dirkclod Moderator
    Staff Member

    Joined:
    May 9, 2014
    Messages:
    10,632
    Likes Received:
    5,696
    Location:
    Amory Mississippi
    Solid red and 4 greens . No blinking .
     
  6. Sergey Zamkovoy

    Joined:
    Nov 9, 2015
    Messages:
    3
    Likes Received:
    0
    It is not just blinking, but also beeping. And it is impossible to run engines...