Ok so my phantom 2 has really gone to pot since V3.04, perhaps its a coincidence but I'm now having problems with the X1 control on the back of the remote. I've done all the calibrations, Ive used the RC software and assistant but I'm not further forward. Basically the camera will only move from one position to another and not in between. A sharp movement on the X1 from one end to the other will make the camera go from 90deg to vertical. If I move the X1 very slowly the gimbal doesn't respond and the camera wont move at all?? So basically, the gimbal will move, but will only respond to a sharp movement from one side of the switch to the other. I hope I have explained this ok. Anyone out there with any suggestions?