I'm having trouble connecting the camera to the iPhone. I turn on the controller, then the wifi extender, then the copter. It connects to the wireless network. When I got into the App (iPhone) It shows the app is connected to the Phantom network, when I hit the camera icon, I can see a 1 still image of whats in front of the camera, but it doesn't go live. Says everything is still connected. If I pick up the vision i don't get any moving images. Most of the time the still image on the app is B&W. When it does come back after a cycle, then its in color
The only fix I have found is power cycling everything off, then on again. Then it usually works properly
My power cycle sequence is: Controller on, WiFi extender on, wait 30-60 seconds, copter on. Connect to phantom network via iPhone, then the camera icon. On the 2nd power cycle it seems to work fine.
I have had to do this same sequence every time time I want to use the camera when flying. Mostly works on 2nd power cycle, but have also had to go as far as 3 cycles.
I have checked the cable from the Vision body, to the camera and they are all secure. I have the latest SW installed.
Any ideas on where to start trouble shooting?
Thanks
Brad
The only fix I have found is power cycling everything off, then on again. Then it usually works properly
My power cycle sequence is: Controller on, WiFi extender on, wait 30-60 seconds, copter on. Connect to phantom network via iPhone, then the camera icon. On the 2nd power cycle it seems to work fine.
I have had to do this same sequence every time time I want to use the camera when flying. Mostly works on 2nd power cycle, but have also had to go as far as 3 cycles.
I have checked the cable from the Vision body, to the camera and they are all secure. I have the latest SW installed.
Any ideas on where to start trouble shooting?
Thanks
Brad