- Joined
- May 14, 2014
- Messages
- 81
- Reaction score
- 0
I've just received my p3 advanced tried to upgrade the firmware on both the aircraft and its controller. Think the aircraft upgraded but I had problems with the controller. I connected the sad card to the controller and turned the controller on. The led light stayed red I gave it some time and after about 5 min it started to beep ( every 2 secs)
After 15 mins I switched it off. Tried it with the aircraft I Can make the camera go up and down but that's all. When I try to start doesn't do anything except at full movement of the throttle control the camera moves a few degrees left and right. I think I got a lemon but it was from B&H as I've heard nothing but good about their service unlike dji which is where I bought my P2 vision and found it impossible to get hold of their customer service people.
Does any know how I can check what firmware rev I have. By the way this is the first time I've been on this forum for several months I'm not sure I like its new format it's not as easy to find you way around
After 15 mins I switched it off. Tried it with the aircraft I Can make the camera go up and down but that's all. When I try to start doesn't do anything except at full movement of the throttle control the camera moves a few degrees left and right. I think I got a lemon but it was from B&H as I've heard nothing but good about their service unlike dji which is where I bought my P2 vision and found it impossible to get hold of their customer service people.
Does any know how I can check what firmware rev I have. By the way this is the first time I've been on this forum for several months I'm not sure I like its new format it's not as easy to find you way around