I installed the new update into my
phantom 4 pro v2.0 and used the dji go 4 method. Finished went out for test flight, for the heck of it I pressed auto takeoff. The drone took off and started climbing like mad. Didn't stopped like it did before update. I got control at 50 feet and landed. I then went back to drawing board and reinstalled update into aircraft and remote using Assistant 2 on PC. USB
Went back out today to test fly, took off using manual mode this time, it flew better, not holding altitude very good, 10 satellites, so I decide to try more altitude and gave it small amount of throttle and at 15 feet it took off straight up again. Didn't stop until it was so high it was hard to see. I tried auto land, nada. So gave it 3/4 throttle down, finally started back down. Had to use a lot of throttle to stop decent, had no control laterally and managed to get it on the ground and shut down. Will not fly it again until I get an answer. Phantom is new, 10 total flights on it, all were good before update.
I posted here, have tried 4 times to put this on DJI forum site and can't get it on. Any questions contact me. Good luck to other Phantom flyers who have spent $1000+ on this toy?