I had a crash the other day. It ripped the gray ribbon looking wires out of the connector going from the drone to the camera. I was able to get them put back in. I cut on the remote, cut on the drone and launch the app and the camera view comes up in the app. I can move the camera up and down, but the display where you can take a picture and switch it from photo to video doesn’t come up. I can start the drone propellers and can fly it but can’t control it very good. The display will not say ready to fly, it says aircraft disconnected. I tried to link the remote and the drone but it will just time out and not link. Any ideas how to fix this issue??