So I've been noticing the last few days flying ( DJI GO) that my bird has taken off at zero alt and returns to same point at -12. Very concerning. Chatted with DJI and they instructed me to downgrade the firmware and then reload the newest. I did that. Went outside to test by running a Litchi waypoint mission. Noticed that my waypoints were designed at 150' but were running closer to 100'. I paused the mission before crashing into building roofs. Had to put in Mode A to get control and fly her back down. This really concerns me as I fly near airports and run mapping missions with dronedeploy. Without a somewhat accurate altitude I'm screwed not to mention it makes autonomous flight impossible.
On a side note, how do you can you change adjust altitude mid Litchi mission?
Is switching mode to A the only way to get control of the bird mid mission?
Can you cancel a Litchi mission mid flight?
Thanks in advance
On a side note, how do you can you change adjust altitude mid Litchi mission?
Is switching mode to A the only way to get control of the bird mid mission?
Can you cancel a Litchi mission mid flight?
Thanks in advance