Hi All – Been following this forum since long, just got a chance to post up my P3S problem..
Long story short – The drone crashed, the battery popped out and the gimbal base plate broke.. No body damage, I opened the body to inspect if anything was broken inside and as far as I could tell, everything seems to be in place.. Finally got some time over this weekend to put back everything together and now I’m have these below issues
Long story short – The drone crashed, the battery popped out and the gimbal base plate broke.. No body damage, I opened the body to inspect if anything was broken inside and as far as I could tell, everything seems to be in place.. Finally got some time over this weekend to put back everything together and now I’m have these below issues
- Downloaded the latest DJI app and it connects to the RC wifi
- The Video feed from the camera is showing up in my android, but the status of the drone shows disconnected
- Red, Green & Yellow lights blink on the drone
- Link button on the drone is green
- Tried Re-linking the Drone to RC, multiple attempts and it just times out both through the app, as well as manual .. In manual mode its just keeps beeping till I turn it off
- The app at once showed firmware upgrade needed and I was able to download it through the app and when I went on to install it the error showed up as device disconnected
- Tried upgrading through the Memory card mode, the first time it started upgrading for few mins and then it failed, the gimbal light became constant red with a continuous Beep
- Tried this multiple times, with mmc reload, flash and just by removing the .txt file.. nothing seems to work..