I am flying a P3P that I have not flowing in 4 mths due to weather and flying restrictions. I am using;
DJI Go 2.41.
AC - 1.4.10
RC - 1.4.30
I took it out today and just about everything went wrong. Compass error problems, switched to ati-mode 3 times and disconnected. It was not a fun 16 min flight. So, I am trying to figure out what is going on and I downloaded my FLYXXX.DAT file and it will only open in machine language. I went to Drones Made Easy > Log Viewer Utility - and I get "No valid data points found", "It is possible that this log was taken while there was not a valid GPS lock".
I correctly calibrated the compass (maybe to many times) I get GPS (although it is a slow process of initializing of about 3 minutes) and only about 12 satellites. Usually I get around 16.
Anyone have any ideas of what is going on???
Thanks,
DJI Go 2.41.
AC - 1.4.10
RC - 1.4.30
I took it out today and just about everything went wrong. Compass error problems, switched to ati-mode 3 times and disconnected. It was not a fun 16 min flight. So, I am trying to figure out what is going on and I downloaded my FLYXXX.DAT file and it will only open in machine language. I went to Drones Made Easy > Log Viewer Utility - and I get "No valid data points found", "It is possible that this log was taken while there was not a valid GPS lock".
I correctly calibrated the compass (maybe to many times) I get GPS (although it is a slow process of initializing of about 3 minutes) and only about 12 satellites. Usually I get around 16.
Anyone have any ideas of what is going on???
Thanks,
