If this has already been resolved, what is the best way to search for it?
I have gone through the procedure of formating the SD card in the Phantom, going to the PC placing the unzipped v1.10.90 bin file into the root of the directory, bringing it back to the P3A and sliding it in until it clicks gently, and then I power it on. It goes through a normal sounding set of load beeps and the four craft lights blink, and the gimbal light blinks green and red for several seconds. Then I hear a couple of buzzes and then a long steady buzz starts and the gimbal light goes solid red and that's where it stays. I have repeated the process at least a dozen times with different SD cards with different speeds and sizes, two 16 Gig, one 32 Gig, one 64 Gig, different company cards and the same result each time. I put in a call on line to DJI, but it has been over a week without help. Does anyone here how any ideas that might help? Thanks in advance.
I have gone through the procedure of formating the SD card in the Phantom, going to the PC placing the unzipped v1.10.90 bin file into the root of the directory, bringing it back to the P3A and sliding it in until it clicks gently, and then I power it on. It goes through a normal sounding set of load beeps and the four craft lights blink, and the gimbal light blinks green and red for several seconds. Then I hear a couple of buzzes and then a long steady buzz starts and the gimbal light goes solid red and that's where it stays. I have repeated the process at least a dozen times with different SD cards with different speeds and sizes, two 16 Gig, one 32 Gig, one 64 Gig, different company cards and the same result each time. I put in a call on line to DJI, but it has been over a week without help. Does anyone here how any ideas that might help? Thanks in advance.