Hello guys !
First of all : thank you very much for your help !
I've (stupidly) updated the firmware of my aircraft (v1.03.0020 --> v1.05.0040) and installed the latest release of DJi Go (v3.1.42).
So, of course, after the update, I lost the possibility to switch on the 2,4GHz... and passed my drone from FCC to EU (or CE) mode !
My first (and last) flight in this configuration was ABSOLUTELY AWFUL : I lost connection (return to home...) at approx 315m away... :s
So I’ve searched on the Internet and fell on this topic ! And thanks to you, I was able to put back my 3SE in FCC mode again !
Since this, I have been able to test the v3.1.8, the v3.1.18 and the patched v3.1.34 DJi Go application versions.
But all of them has problems (some minor, some major).
v3.1.8 : many video drops/glitches. “Follow me” mode doesn't work. Unstable (crashed 2 or 3 times during its use).
v3.1.18 : so far, the best and most stable version, but with some video drops/glitches. Application is in a strange "forced landscape mode” (even in the home page... what is really not nice and not ergonomic !).
v3.1.34 : stable and less video drops/glitches than other releases, but with ANNOYING popups ! (sometimes, I had 5 popups in less than 3 minutes !) : I cannot use it... It's beyond my acceptance capacity...
So I’ve decided to let the v3.1.18 on my MiMax2
But I have a last question for you, guys :
Actually, in v3.1.18, in the REMOTE CONTROL SETTINGS section of DJi Go, I can choose between 2,4GHz (11 channels (=FCC mode) instead of 13 channel (=EU mode). Thanks to you, once again ! ;-) ) and 5GHz (by default, it's set on 5GHz band).
If I well understood, this setting represent the wifi band on which the drone and the remote are connected.
If you choose here (in the application) the 5GHz band, the wifi between your remote and your phone will switch onto 2,4GHz.
If you choose here (in the application) the 2,4GHz band, the wifi between your remote and your phone will switch onto 5GHz. This is (from what I’ve read) the best solution to have the best range with your aircraft, isn’t it ?!
Am I right ?!
Unfortunately, since I did the firmware update, I cannot change successfully to 2,4GHz anymore. If I choose this option in DJi Go (2,4GHz), it says me that it will restart the wifi, and that I have to wait for the auto-reconnection…
But it doesn’t work ! I see nowhere my “Phantom3SE WiFi”. Of course, I check on my MiMax 2, on the 2,4GHz and 5GHz bands. But it seems that my “Phantom 3SE WiFi” just disappears…
I have to “reboot” my remote to see the WiFi again, but of course, it’s back to the 2,4GHz band (unfortunately) !
I think that it’s a consequence of the last firmware update… :s
Do you think that if I switch back to the v1.03.0020 (now that I am in FCC mode), I could switch to 2,4GHz band again ?
Thanks for your precious help, and for your answers
Bye,
Jojo