I'm hoping one of you might be able to help me figure this out.
I've had my P2V+ for two weeks and have had it out and flying four times. Yesterday I flew it around the yard, landed safely and called it a day.
Today I wanted to practice so I went through my start up procedure...
Remove guards
Power on remote (S1 & S2 in top position)
Power on range extender
Power on Drone
Link iPhone wifi to Phantom
Open DJI app
Wait for 6+ satelites
Perform compass calibration
Confirm slowly blinking green lights
At this point I pull RC sticks into bottom inside corners (5 & 7 o'clock)
Nothing happens.
The left stick sticks in the down lock position but I always release it immediately.
Upon release of left stick rear Drone lights flash red 3 times then return to slowly flashing green.
The motors do not come on.
Can anyone tell me what I'm missing or doing wrong?
Screenshot of iPhone is attached.
Thanks in advance!
Rebecca
PS. I powered off and started again three times. I calibrated the compass two of those times.
I've had my P2V+ for two weeks and have had it out and flying four times. Yesterday I flew it around the yard, landed safely and called it a day.
Today I wanted to practice so I went through my start up procedure...
Remove guards
Power on remote (S1 & S2 in top position)
Power on range extender
Power on Drone
Link iPhone wifi to Phantom
Open DJI app
Wait for 6+ satelites
Perform compass calibration
Confirm slowly blinking green lights
At this point I pull RC sticks into bottom inside corners (5 & 7 o'clock)
Nothing happens.
The left stick sticks in the down lock position but I always release it immediately.
Upon release of left stick rear Drone lights flash red 3 times then return to slowly flashing green.
The motors do not come on.
Can anyone tell me what I'm missing or doing wrong?
Screenshot of iPhone is attached.
Thanks in advance!
Rebecca
PS. I powered off and started again three times. I calibrated the compass two of those times.