The receiver plate of the original GPS module in my P2V is cracked. So I bought a replacement (genuine DJI part, same part number - DJI 11-22 V2). But my P2V had it's compass connected to a header on the GPS module... and that header is missing on the new replacement (there are traces on the PCB, but no "jack").
I noticed the main logic board has a COMP header, but plugging the compass in there doesn't not seem to work (bird signals no compass, and will not start motors).
Is there a firmware setting that would activate the COMP jack on the main board? Do some P2Vs run the compass there, or do they all go to the GPS board? Did I just get the wrong GPS module, even though it's the same part number?
TIA!
-C
I noticed the main logic board has a COMP header, but plugging the compass in there doesn't not seem to work (bird signals no compass, and will not start motors).
Is there a firmware setting that would activate the COMP jack on the main board? Do some P2Vs run the compass there, or do they all go to the GPS board? Did I just get the wrong GPS module, even though it's the same part number?
TIA!
-C