Hi guys I am a newbie I need some advice on where to start. Every thing was working fine till yesterday till I plugged it in to check updates. As soon as I plugged it in it said there was an update for language. I installed this. Now the only thing that works is the wheel on the transmitter to make the camera tilt up and down. The lights are solid red. Please help me on where to start to correct this problem. Thank you in advance I will check back at 11.00EST
Sorry I have phantom 2 vision plus with the upgrade
I also have the new controller but it dose not show in the assistant
I also added the ITE-DBSO1
I fired up the assistant software and did a cal on the sticks still shows old controller but I was able to get rid of the solid red light. Now I have a flashing yellow which is understandable because I am inside but the motors will still not start.
I am trying to give you the most information I can again thank you
Sorry I have phantom 2 vision plus with the upgrade
I also have the new controller but it dose not show in the assistant
I also added the ITE-DBSO1
I fired up the assistant software and did a cal on the sticks still shows old controller but I was able to get rid of the solid red light. Now I have a flashing yellow which is understandable because I am inside but the motors will still not start.
I am trying to give you the most information I can again thank you
Attachments
Last edited: