crashed my p3 standard from 40ft, bent gimbal and tore camera ribbon cable. before repairs camera still had live feed, green led light very little left/right movement and no tilt unless I played with the ribbon. once in a while gimbal overload would show up. replaced gimbal and cable with fstoplabs part. was very carefull on repair process also. after repairing I turned on drone and the camera does not self check, no movement via rc controller but craft flies normal, I have live feed from camera and it takes pictures. gimbal status light is green. imu is calibrated, when I do gimbal calibration is does nothing. could this be a bad brand new cable seeing it was not a dji oem part? debating weather to try a new cable, get a whole new gimbal/camera set up or just call it lost and buy a replacement drone. any suggestions would be appreciated. also overall status has gimbal gyroscope hardware error.
Last edited:
