I'll stick to the bullet points to keep it short.
- It's a non-v P2
- I just replaced my 200mw trans with a 600w/Immersion. It looked great on the BP 7" monitor
- Hooked it up to DJI Assistant like I always do. It worked fine.
- --I suspected the compass might be a little off due to the fact after I had it on the
bench for a while I noticed the quad was near a magnetic screw holder. - The Mod setting was just a little out of range so I watched a video and was going
to do the fix which consisted of moving a magnet around the quad. - I went to switch to a longer PC to quad cable which is a little longer than the
one that came with the quad. It fit perfectly and I swear I have used this before but I may
have gotten it mixed up with another that looks just like it. - All of a sudden my quat starts beeping.
- There is no gimbel calibration movement
- The software no longer recognizes the Phantom.
- Is it possible that since I was just under the hook to wire the new transmitter up that I didn't secure
something and it is a coincidence that it comes apart now? I know that's wishful thinking. - Anyway I hope some of you guys can lead me in the right direction for troubleshooting.
- Where you at Jason?????????????\
- Fully charged batteries.
- Thank You All
- Oh yes, I do have the gopro inthe gimbel and yes I do have the antenna on the Transmitter.