hello, here I am, even last night until 2 am ....
an important question ... I read a guy who wrote that if the red led of the card that I'm programming WM301_DM368_V1 is turned on a little the card is not going, but if you turn it on well the card is ok ... mine comes on weak. ..
what I did not understand is that even if you turn on little is just because of the firmware or the card is to be thrown away (in this case I avoid wasting time ... and I resign)?
So I have little news and other questions, because as usual I do not understand ...
Ho installato python nel mio pc e ho letto come eseguire i comandi che hai scritto al punto 2 ...
I installed python in my pc and I read how to execute the commands you wrote in point 2 ... it remains a big problem ... the firmware for the phantom vision plus are not on the dji site ... wifi I have the writing WM301_DM368_V1 and not even in the table with all the firmware is present ...
the firmware for the vision plus is not on the dji site and is not even present in the table you sent me ... I have a wifi card written WM301_DM368_V1 and I can not find it ... I find instead the one you wrote DM365. .. can I use that? Does it look like a phantom 3?
Yesterday I read the whole forum that you have marked me but I still do not understand the steps ... The wifi card I have to connect it to the drone when I program it or can I program it isolated (how I'm doing)?
è stata la tua esperienza su una visione fantasma più o 3? Il metodo è sempre lo stesso?
Ultima cosa ... Deluso dalla situazione sempre ieri sera ho ricaricato il firmware della guida (sfh_DM36x.exe -nandflash -v -p "COM6" ubl1_editedByGaucho.img u-boot_modifiedByGaucho.img), poi ho eseguito l'extraputty seguito da dji- firmware-tools wiki - Flashing kernel, e usando la funzione ymodem send ho inviato il file uImage sempre all'interno del Gaucho zip, ha completato tutto, non ho visto errori ma alla fine .... niente ... si è fermato sempre nel stesso punto ...
was your experience on a phantom vision plus or 3? Is the method always the same? Last thing... Disappointed from the situation always yesterday evening I reloaded the firmware of the guide (sfh_DM36x.exe -nandflash -v -p "COM6" ubl1_editedByGaucho.img u-boot_modifiedByGaucho.img), then I ran extraputty followed by dji-firmware-tools wiki - Flashing kernel, and using the function ymodem send I sent the file uImage always inside the Gaucho zip, it completed everything, I did not see errors but in the end .... nothing ... always stopped in the same point ... help help