I have recently installed the upgrade board and the Zenmuse H3-2D gimbal to my Phantom 1.1.1, which works great. But I have now purchased an FPV screen and a Boscam 400mw 5.8ghz Tx and I am struggling to find any advice on how to install the Tx to the phantom upgrade board.
I am a novice when it comes to soldering but I did have to do quite a bit when installing the upgrade board so I am at least capable of doing it. My problem is that I have very little knowledge of electronics and I need to understand what needs to be connected where.. I am quite happy to connect the power for the FPV through the balance cable from the main LiPo and I'm not even fussed about a 'clean' installation inside the Phantom either. I just want to get it all working.
Has anyone done this or can anyone offer me some advice? Thanks!!
I am a novice when it comes to soldering but I did have to do quite a bit when installing the upgrade board so I am at least capable of doing it. My problem is that I have very little knowledge of electronics and I need to understand what needs to be connected where.. I am quite happy to connect the power for the FPV through the balance cable from the main LiPo and I'm not even fussed about a 'clean' installation inside the Phantom either. I just want to get it all working.
Has anyone done this or can anyone offer me some advice? Thanks!!