Tahoe Ed said:Some soldering will be required but not as much as without the HUB. I would imagine someone will come up with custom cables for specific vTx's.
adanac said:http://www.firstpersonview.com/cables/phantom-2-iosd-mini-transmitter
erek said:adanac said:http://www.firstpersonview.com/cables/phantom-2-iosd-mini-transmitter
with this Plug and Play Cable the IRC 600mW Transmitter interfaces with the iOSD Mini instead of plugging into the VTX port of the FPV Hub? I am considering upgrading from the AVL58 to the IRC 600mW and was looking for a simple no-soldering solution.
OI Photography said:erek said:adanac said:http://www.firstpersonview.com/cables/phantom-2-iosd-mini-transmitter
with this Plug and Play Cable the IRC 600mW Transmitter interfaces with the iOSD Mini instead of plugging into the VTX port of the FPV Hub? I am considering upgrading from the AVL58 to the IRC 600mW and was looking for a simple no-soldering solution.
That cable would basically replace your FPV hub, if that's what you're using now. Your gimbal cable would connect straight to the Phantom's mainboard instead, and that cable adanac linked would go from the mainboard to the iOSD mini and then on to the IRC Tx, feeding it video and power as well.
adanac said:I'd like to install the immersionrc 600mW vtx and the iosd mini. Will the DJI fpv hub allow it all to come together without soldering?
erek said:would this cable suit me better seeing that i'm using the FPV Hub?
http://www.dpcav.com/xcart/Video-Cable- ... Shark.html