Hey Guys,
I am about to solder my Tx (ImmersionRC 600mW), but before that, I wanted to hide the interference board for H3-3D inside the shell.
I have tried to unscrew the small phillips screw at the end of each arm, and I know that the WIHA 00-40mm works best, but I don't have it, so I bought a no-name 00-40mm.. and the screws were either really tight, or the noname screwdriver wasn't the right fit, but I have stripped the screws (not all the way, but they are not how they were before)... I have two choices, wait for the WIHA to come by mail, and try it.. not sure if it will unscrew the damaged screws.. or try and remove them by either drilling, or using some special tool (will destroy the screw though).. I'm afraid to do this, since I don't want to damage the plastic threading of the shell, and I don't know how the thread hole looks.. and how deep I can drill...
My other question is, if I just place the interference board on the outside beside the Tx, will this create any interference between the Tx and the board?? (i don't have the osdmini)
Thanks a lot for any suggestions!
Eugene
I am about to solder my Tx (ImmersionRC 600mW), but before that, I wanted to hide the interference board for H3-3D inside the shell.
I have tried to unscrew the small phillips screw at the end of each arm, and I know that the WIHA 00-40mm works best, but I don't have it, so I bought a no-name 00-40mm.. and the screws were either really tight, or the noname screwdriver wasn't the right fit, but I have stripped the screws (not all the way, but they are not how they were before)... I have two choices, wait for the WIHA to come by mail, and try it.. not sure if it will unscrew the damaged screws.. or try and remove them by either drilling, or using some special tool (will destroy the screw though).. I'm afraid to do this, since I don't want to damage the plastic threading of the shell, and I don't know how the thread hole looks.. and how deep I can drill...
My other question is, if I just place the interference board on the outside beside the Tx, will this create any interference between the Tx and the board?? (i don't have the osdmini)
Thanks a lot for any suggestions!
Eugene