JDN said:I'm seeing some of your same issues, Tristan1234. I have re-calibrated X1 several times now and it does not operate the same, as it did "out of the box'". I attribute this to the fact that I upgraded firmware to V3.04 (along with the other associated upgrades to the various firmwares on the Phantom.) That's when I started having problems with my H3-3D not 'stopping' in-between the UP and DOWN positions of the switch. It worked much better before the upgrade, but I can still stop it in-between if I move the X1 lever VERY slowly. However, it seems to have a very narrow range now between fully UP or fully DOWN...like maybe a 1/4 of the travel distance of the X1 lever and it goes either fully UP or fully DOWN, leaving the other 3/4 of the travel distance of the X1 lever absolutely useless. I've re-calibrated X1 several times and can not get it to change to use the entire travel distance of the X1 lever.
Try following these directions:
viewtopic.php?f=37&t=23621