I'm a newbie to UAV so don't assume too much about my knowledge.
I want to make sure I understand the Ground Station system. Can I assume that if I have a P2 that all I need is the Ground Station hardware and software and it will allow me to specify waypoints that the P2 will visit?
In other words, I get the impression that I can program 10 ways points into the Ground Station software and then launch the P2 and watch it visit the waypoints I programmed while I sit back and watch. Hands off the transmitter. Is that correct?
http://www.dji.com/product/ipad-ground-station/
In case it matters, I don't have an iPad, I was planning on using the PC version of the software to program waypoints.
I want to make sure I understand the Ground Station system. Can I assume that if I have a P2 that all I need is the Ground Station hardware and software and it will allow me to specify waypoints that the P2 will visit?
In other words, I get the impression that I can program 10 ways points into the Ground Station software and then launch the P2 and watch it visit the waypoints I programmed while I sit back and watch. Hands off the transmitter. Is that correct?
http://www.dji.com/product/ipad-ground-station/
In case it matters, I don't have an iPad, I was planning on using the PC version of the software to program waypoints.